Value Collection MPFFI-1001750-100BX 10-32 Flat Head Screw

Product Description

The VALUE COLLECTION MPFFI-1001750-100BX is a 10-32 x 1-3/4 inch flat head Phillips machine screw supplied in a box of 100. Constructed from Grade 2 steel with a zinc-plated finish, this screw follows Unified National Fine (UNF) thread standards and is sized for overall length measurement. The flat head profile sits flush with or below the mating surface when fully driven, making it well suited for assemblies where a low-profile fastener is required. Electricians, HVAC technicians, and general trade professionals stock these for panel work, equipment mounting, and light structural assembly.

These screws are commonly used in residential and light commercial applications wherever a 10-32 UNF threaded hole or nut is specified. Typical install scenarios include control panel assembly, electrical enclosures, HVAC equipment covers, and general sheet-metal or fabricated-steel assemblies. The Phillips drive is compatible with standard No. 2 Phillips bits, which are universally carried by trade technicians. This 100-count box quantity suits service vans and shop stock alike.

Key Features

• 10-32 UNF thread for precise engagement in fine-threaded holes and hardware
• Flat head design allows flush or countersunk seating in mating materials
• Phillips drive compatible with standard No. 2 bits and impact drivers
• Zinc-plated finish provides basic corrosion resistance for indoor and sheltered applications
• Grade 2 steel construction meets general-purpose fastener requirements
• 100-count packaging supports bulk stocking and field use

Compatibility

Designed for use in any application requiring a 10-32 UNF flat head Phillips machine screw, including electrical enclosures, control panels, and light-duty equipment assemblies.

Installation Notes

Install using a No. 2 Phillips screwdriver or compatible bit driver. Ensure the mating hole or threaded insert is clean and properly tapped to 10-32 UNF before driving. De-energize any electrical equipment before fastening hardware on or near energized panels, following applicable NEC guidelines. Do not overtighten, as Grade 2 steel has lower tensile strength than higher-grade fasteners and may be susceptible to thread stripping if torque is excessive.