Value Collection MPFFI-1000310-100BX 10-32 Flat Head Phillips Screw

Product Description

The VALUE COLLECTION MPFFI-1000310-100BX is a 10-32 x 5/16-inch flat head Phillips machine screw sold in a 100-piece box. Manufactured from Grade 2 steel with a zinc-plated finish, this screw follows Unified National Fine (UNF) thread standards. The flat head profile sits flush with the mating surface when fully driven, making it well suited for applications where a low-profile, countersunk installation is required. Overall length is 5/16 inches, measured from tip to the top of the head. Electricians, HVAC technicians, and general tradespeople commonly stock this fastener for panel assembly, equipment mounting, and light structural work.

This fastener is used across a wide range of trade and light industrial applications including electrical panel construction, HVAC equipment assembly, control box fabrication, and general mechanical assembly. The 10-32 UNF thread is a common fine-thread standard found in electronic enclosures, sheet metal assemblies, and OEM equipment. The zinc coating provides moderate corrosion resistance suitable for indoor and sheltered environments. Each order unit contains 100 screws, making it a practical stock quantity for service vans, shop bins, or job-site kits.

Key Features

• 10-32 UNF fine thread for reliable engagement in tapped holes and threaded inserts
• Flat head design allows flush, countersunk installation in sheet metal and panel work
• Phillips drive compatible with standard Phillips bits and screwdrivers
• Grade 2 steel construction provides adequate strength for light-duty mechanical and electrical applications
• Zinc-plated finish offers corrosion resistance for indoor and sheltered installations
• Sold in a 100-piece box for convenient restocking and bin inventory

Compatibility

Designed as a standard 10-32 UNF flat head Phillips machine screw suitable for any application requiring a flush-seating fastener in pre-tapped holes or threaded inserts of matching thread specification.

Installation Notes

Install with a Phillips screwdriver or Phillips-tip power driver sized for the screw head. Ensure the receiving hole is properly tapped or fitted with a matching 10-32 threaded insert before driving. Do not overtorque, as Grade 2 steel has lower tensile strength than higher-grade fasteners and stripping is possible under excessive load. For electrical enclosure work, follow applicable NEC requirements for panel assembly and hardware.