Value Collection MP02880 Concrete Masonry Screw 25-pack

Product Description

The VALUE COLLECTION MP02880 is a stainless steel concrete masonry screw designed for direct fastening into concrete, block, and masonry substrates without requiring an anchor insert. The 1/4 inch diameter, 1-1/4 inch overall length screw features a hex drive for positive torque transfer and is manufactured from 304 stainless steel for corrosion resistance in demanding environments. Rated to ICC-ES ESR-2202, this fastener meets recognized evaluation standards for masonry anchoring applications. Each package includes a drill bit for field use. Sold in a package of 25 screws.

This masonry screw is suited for light-duty fastening tasks where threaded concrete anchoring is required in residential and commercial construction settings. Typical applications include securing electrical conduit straps, pipe hangers, junction box brackets, equipment bases, and similar hardware directly to poured concrete, concrete masonry units (CMU), or brick. The 1/4 inch diameter and short 1-1/4 inch length make it appropriate for thin-section attachments where a longer fastener would penetrate too deep or break through the substrate.

Key Features

• 304 stainless steel construction resists corrosion in wet and outdoor masonry environments
• Hex drive design provides reliable torque transfer and reduces bit cam-out
• ICC-ES ESR-2202 rated for recognized performance standards in masonry anchoring
• Includes drill bit for consistent hole sizing and field installation
• 1/4 inch diameter with length measured under head for accurate embedment depth planning
• Sold in a 25-count package to support single-trade service calls and small installations

Compatibility

Designed as a direct-thread masonry fastener for use in concrete, CMU block, and brick substrates where ICC-ES ESR-2202 compliant anchoring is specified.

Installation Notes

Installation is typically performed by licensed electricians, plumbers, or general contractors working to applicable building and mechanical codes. Pre-drill with the included bit to the required embedment depth before driving the screw. Do not overdrive — torque to snug contact without stripping the masonry thread. Follow ICC-ES ESR-2202 guidelines and local code requirements for minimum edge distance and anchor spacing.