Value Collection LSNY1-3.7 Locking Fork Terminal 100 Pack

Product Description

The VALUE COLLECTION LSNY1-3.7 is a partially insulated locking fork terminal designed for reliable crimp connections in low-voltage wiring applications. Constructed with a copper contact body finished in TiN plating and a red nylon insulation sleeve, this terminal accepts wire sizes from 0.5 to 1.5 square millimeters and is rated for up to 600 volts. The locking fork design fits a No. 6 stud (3.70 mm), holding the terminal securely on the stud post even before the fastener is fully tightened. Electricians and panel wiring technicians use these terminals to terminate control wiring, sensor leads, and low-current circuits in electrical panels, HVAC controls, and instrumentation enclosures.

This terminal is suited for residential and light commercial electrical work where compact, secure wire terminations are required. The 0.89-inch overall length and 0.252-inch fork width keep the footprint small, making it practical in tight terminal blocks and control boards. The partially insulated barrel protects the wire entry point while leaving the fork open for stud mounting. This package contains 100 terminals, supporting production runs, service truck stocking, or multi-point wiring jobs without repeated reorders.

Key Features

• Locking fork design secures to No. 6 stud (3.70 mm) and resists backing off under vibration
• Accepts 0.5 to 1.5 sq mm wire range with crimp termination for a gas-tight connection
• 600-volt rating suits control circuit and low-voltage panel wiring applications
• Copper contact with TiN plating resists corrosion and maintains low contact resistance
• Red nylon partial insulation provides wire entry protection and color-coded wire range identification
• 100-piece package quantity supports high-volume wiring jobs and service inventory stocking

Compatibility

Designed as an OEM-style replacement or new-installation crimp terminal for use with No. 6 stud fasteners and wire gauges in the 0.5 to 1.5 square millimeter range, consistent with common control wiring and instrumentation applications.

Installation Notes

Electricians should de-energize and lock out the circuit before terminating or disturbing any wiring. Use a calibrated ratcheting crimp tool sized for the 0.5 to 1.5 sq mm wire range to achieve a proper crimp; a poorly crimped terminal can cause high resistance or pull-out failure. Slide the fork over the stud before tightening the fastener, and verify the locking tab is properly seated. Installation should conform to NEC requirements for the applicable circuit type and enclosure rating.