Value Collection KP66327 Pvc Pipe Coupling 3 in Slip X Slip

Product Description

The VALUE COLLECTION KP66327 is a 3-inch PVC slip x slip pipe coupling designed for joining two sections of PVC pipe in a straight run. Constructed from PVC, this coupling accepts a standard solvent-weld connection on both ends, creating a leak-resistant joint when properly primed and cemented. It is a standard-duty fitting suited for cold and ambient-temperature water distribution, drain, waste, and vent (DWV) piping, as well as irrigation and general-purpose fluid conveyance systems. Plumbers and pipefitters install this type of fitting during new construction, repair, or system extension work.

This coupling is intended for residential and light commercial plumbing and irrigation applications where a 3-inch slip-style PVC fitting is required. It is used to connect two plain-end PVC pipe sections in a continuous straight run, making it a common repair and installation component in supply lines, irrigation mains, and DWV systems. No threaded connections are involved; both ends accept solvent cement bonding.

Key Features

• 3-inch fitting size fits standard 3-inch PVC pipe outside diameter
• Slip x slip end connections accept solvent-weld (primer and cement) bonding on both ends
• PVC construction offers corrosion resistance and compatibility with water and many chemical solutions
• Lightweight design simplifies handling in tight spaces
• Single-piece quantity suitable for spot repairs or single-joint installations

Compatibility

Designed as an OEM-style replacement or standard fitting for 3-inch PVC piping systems using slip-style solvent-weld connections.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters following applicable IPC or local plumbing code requirements. Shut off the water supply and depressurize the line before cutting into any existing piping. Both the pipe ends and the coupling socket must be cleaned, primed, and solvent-cemented per the cement manufacturer's instructions; allow full cure time before restoring flow. Do not use this fitting on pressurized systems that exceed the pressure rating of standard Schedule 40 or Schedule 80 PVC pipe, and do not use solvent-weld fittings on threaded or push-fit connections.