Value Collection KP24272 Flat Washer 7/8 in Steel Black Oxide 25pk

Product Description

The VALUE COLLECTION KP24272 is a standard flat washer designed for use with 7/8 inch fasteners. Manufactured from 1010 steel with a black oxide finish, it provides basic corrosion resistance in indoor and light-duty applications. The washer measures 29/32 inches (0.9063 inches) inner diameter, 1-3/4 inches (1.7500 inches) outer diameter, and 5/32 inches (0.1563 inches) thick. It follows inch measurement standards and is sold in packs of 25. Electricians, plumbers, HVAC technicians, and general maintenance professionals use these washers to distribute load under bolt heads and nuts, reduce surface damage, and prevent fastener pull-through on standard assemblies.

This washer is suited for a broad range of general mechanical and structural fastening applications. It fits residential and light commercial work wherever a 7/8 inch screw or bolt is used. Common install scenarios include equipment mounting, panel attachment, pipe hanger assembly, and general mechanical work. The black oxide finish blends with ferrous hardware and provides a mild level of moisture resistance for interior use. Each pack contains 25 washers, making it practical to stock for ongoing service work.

Key Features

• 1010 steel construction for reliable strength in standard fastening applications
• Black oxide finish provides light corrosion resistance for interior and covered environments
• 29/32 inch inner diameter fits 7/8 inch screws and bolts with standard clearance
• 1-3/4 inch outer diameter distributes clamp load over a wide bearing surface
• 5/32 inch thickness meets standard flat washer dimensional requirements
• Inch measurement system for direct compatibility with imperial hardware

Compatibility

Designed as a standard flat washer for use with 7/8 inch screws and bolts in general-purpose inch-series fastening assemblies.

Installation Notes

Standard flat washers are installed by placing trades including electricians, plumbers, and HVAC technicians as part of routine fastening work. Always de-energize electrical systems and shut off fluid or gas supply before working in the area where fasteners are being tightened or replaced. Use appropriate hand tools and follow applicable codes such as NEC or IFGC where fastener connections are part of a regulated assembly. Do not substitute washers of a different grade or thickness where a specific fastener specification is required.