Value Collection J06-00413 Rotating Pressure Washer Nozzle

Product Description

The VALUE COLLECTION J06-00413 is a rotating pressure washer nozzle rated for a maximum operating pressure of 5,800 psi. The nozzle features a 0.12-inch orifice diameter and connects via a standard 1/4-inch thread fitting. The rotating design spins the water stream to deliver a wider, more aggressive cleaning pattern compared to a fixed-angle nozzle. It is suited for use in demanding cleaning applications where high-pressure output and broad surface coverage are both required. Installation and service are typically handled by pressure washing contractors, facilities maintenance technicians, and experienced equipment operators.

This nozzle is intended for use with pressure washing equipment capable of operating at or below 5,800 psi. The 1/4-inch threaded inlet is a common connection standard found on a wide range of consumer and commercial pressure washer wands and lances. The rotating spray pattern makes this nozzle appropriate for surface preparation, equipment cleaning, concrete and masonry cleaning, and similar high-pressure wash-down tasks where a turbo-style cleaning action is needed.

Key Features

• Rotating nozzle design delivers a spinning turbo spray pattern for aggressive surface cleaning
• Rated to a maximum of 5,800 psi for use with high-output pressure washing equipment
• 0.12-inch orifice diameter controls flow rate and spray intensity
• 1/4-inch threaded connection is compatible with standard pressure washer wands and lances
• Compact form factor suited for both handheld wand and fixed-mount lance applications

Compatibility

Designed as a replacement or spare rotating nozzle for pressure washers equipped with a standard 1/4-inch threaded wand or lance inlet and rated to handle up to 5,800 psi operating pressure.

Installation Notes

Installation is typically performed by pressure washing technicians or qualified equipment operators. Before replacing or changing nozzles, relieve all pressure from the system and confirm the pump is fully shut off. Thread the nozzle onto the wand inlet by hand first, then snug with the appropriate wrench, taking care not to cross-thread the fitting. Never direct the spray at personnel, and always verify the equipment pressure rating does not exceed the nozzle maximum of 5,800 psi before operation.