Value Collection IRECRB-3-BKN Recessed Rubber Bumper 50pk

Product Description

The VALUE COLLECTION IRECRB-3-BKN is a recessed rubber bumper designed to protect surfaces from impact, vibration, and abrasion in light industrial, HVAC panel, and equipment enclosure applications. The bumper features a 5/16-inch thread for secure threaded installation into metal or composite panels. At 5/8 inches in overall height and 1 inch in overall width, this black rubber bumper sits flush within a recessed mount to minimize protrusion while still providing effective cushioning. With a C-projection gage line to nose end of 5/16 inches and a minor axis of 5/8 inches, the bumper is well suited for sheet metal enclosures, electrical panels, and equipment doors where controlled contact points are needed. This listing is sold as a pack of 50 units.

Recessed bumpers of this type are commonly used by HVAC technicians, electricians, and equipment assemblers to protect cabinet doors, access panels, and junction box covers from metal-to-metal contact. The threaded design allows installation directly into pre-tapped holes in sheet metal or structural panels without additional hardware. The black rubber construction resists mild oils and shop-floor conditions typical of residential and light commercial mechanical rooms and electrical enclosures.

Key Features

• Recessed profile minimizes protrusion while maintaining impact and vibration protection
• 5/16-inch threaded stud for direct installation into pre-tapped mounting holes
• 5/8-inch overall height with 1-inch overall width for consistent surface contact
• Black rubber material resists mild oils and common shop-floor contaminants
• Sold in packs of 50 for service truck stocking and panel assembly work
• Lightweight at 0.01 pounds per piece for use in weight-sensitive enclosure applications

Compatibility

Designed as a standard threaded recessed rubber bumper suitable for sheet metal panels, electrical enclosures, equipment cabinet doors, and HVAC access panels with pre-tapped 5/16-inch mounting holes.

Installation Notes

Installation requires a pre-tapped 5/16-inch hole in the mounting surface. Thread the bumper stud in by hand and tighten with an appropriate wrench or socket until the bumper seats flush in the recessed mount. Power down or de-energize any electrical enclosure before working inside the panel. Inspect the mounting surface for thread damage or corrosion before installation to ensure a secure fit.