Value Collection HC3X10035-025BX M10 Hex Cap Screw 18-8 Ss Din 933

Product Description

The VALUE COLLECTION HC3X10035-025BX is a fully threaded hex head cap screw conforming to DIN 933 standards. It is manufactured from 18-8 austenitic stainless steel, Grade A2, with a bright uncoated finish. The fastener measures M10 x 1.50 mm thread pitch with a 35 mm length under the head and accepts a 17 mm hex drive. This screw is sold in a minimum order quantity of 25 pieces and is installed by millwrights, pipefitters, electricians, HVAC technicians, and mechanical contractors wherever a metric stainless fastener is specified.

This hex head cap screw suits metric fastening applications in HVAC equipment, plumbing assemblies, pool equipment enclosures, electrical panel frames, and general mechanical installations where corrosion resistance is required. The A2 stainless grade performs well in wet or humid environments, including indoor and light outdoor service conditions. Fully threaded along the entire shank length, it provides consistent thread engagement across the full 35 mm length under the head.

Key Features

• DIN 933 fully threaded hex head cap screw configuration
• 18-8 austenitic stainless steel, Grade A2 for corrosion resistance
• M10 x 1.50 mm thread pitch with 35 mm length under head
• 17 mm hex drive fits standard metric combination and box wrenches
• Bright uncoated finish — no plating to chip, flake, or react with dissimilar metals
• Sold in multiples of 25 pieces per order

Compatibility

Designed for use in any application specifying a DIN 933 M10 x 1.50 x 35 mm fully threaded hex head cap screw in 18-8 or A2 stainless steel.

Installation Notes

Installation requires a 17 mm metric wrench or socket driver. De-energize and lock out electrical equipment before fastening components inside panels or enclosures, in accordance with applicable NFPA 70E procedures. When torquing stainless steel fasteners, apply an appropriate anti-seize compound to prevent galling, a common issue with austenitic stainless threads. Do not mix with non-metric or inch-series hardware in the same tapped hole.