Value Collection G300 32 Malleable Iron End Cap 1-1/4 in

Product Description

The VALUE COLLECTION G300 32 is a malleable iron threaded pipe end cap designed to seal the open end of a 1-1/4 inch pipe. It provides a pressure-rated termination point in liquid, gas, and steam piping systems. The fitting carries a 300 psi rating for liquid and gas service and a 150 psi rating for steam, making it suitable for a broad range of mechanical and process piping applications. The galvanized finish provides corrosion resistance for use in exposed or moderately harsh environments. Licensed plumbers, pipefitters, and mechanical contractors typically install this fitting during rough-in, system modification, or maintenance work.

This end cap is used in residential and commercial piping systems where a threaded pipe run must be capped off permanently or temporarily. Common applications include natural gas distribution lines, compressed air systems, water supply lines, and low-pressure steam systems. The Class 150 malleable iron construction meets ANSI/ASME B1.20.1 thread standards, ensuring reliable engagement with standard NPT threaded pipe. It is well suited for mechanical rooms, utility spaces, and inline shutoff points on branch piping.

Key Features

• 300 psi liquid and gas pressure rating for demanding service conditions
• 150 psi steam pressure rating for low-pressure steam piping
• Threaded end connection conforming to ANSI/ASME B1.20.1 NPT standards
• Malleable iron construction for durability and impact resistance
• Galvanized finish for added corrosion protection
• Class 150 fitting suitable for a wide range of mechanical piping applications

Compatibility

Designed as an OEM-style replacement or standard service fitting for 1-1/4 inch NPT threaded pipe systems in liquid, gas, and steam service.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local codes and the International Fuel Gas Code or International Plumbing Code where required. Shut off and depressurize the piping system completely before removing or installing any threaded fittings. Apply an appropriate thread sealant or PTFE tape to the male threads before engagement. Do not over-tighten; use a pipe wrench sized appropriately for the fitting to avoid cracking the casting.