Value Collection G240 40X25 Reducing Coupling 1-1/2x1 in

Product Description

The VALUE COLLECTION G240 40X25 is a malleable iron reducing coupling designed to connect pipes of two different diameters within a threaded piping system. It transitions from a 1-1/2-inch pipe to a 1-inch pipe using standard threaded end connections on both ends. Rated at 300 psi for liquid and gas service and 150 psi for steam, this fitting is built to Class 150 specifications and meets ISO 7/1 threading standards. The galvanized finish provides corrosion resistance for use in a range of service environments. Plumbers and pipefitters install this fitting in both new construction and retrofit applications.

This reducing coupling is suited for residential and light commercial plumbing, gas distribution, and hydronic systems where a threaded pipe size reduction is required inline. The 1-1/2 x 1-inch size change makes it a common choice in branch line reductions and fixture supply lines. Its pressure ratings support both low-pressure steam and standard liquid and gas piping configurations.

Key Features

• Malleable iron construction for strength and impact resistance in threaded piping systems
• Galvanized finish for corrosion protection in wet or humid environments
• 300 psi liquid and gas pressure rating for demanding service conditions
• 150 psi steam pressure rating suitable for low-pressure steam systems
• Threaded end connections on both ends comply with ISO 7/1 standards
• Class 150 fitting consistent with standard commercial and residential piping specifications

Compatibility

Designed as an OEM-style threaded replacement fitting for malleable iron piping systems requiring an inline reduction from 1-1/2-inch to 1-inch pipe diameter.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC or IFGC requirements for threaded pipe assemblies. Shut off and depressurize the supply line fully before removing or installing any fitting. Apply appropriate pipe thread sealant or PTFE tape to all male threads before assembly. Do not overtighten threaded connections, as malleable iron fittings can crack if excessive torque is applied.