Value Collection G180 25 Malleable Iron Pipe Cross 1 Inch

Product Description

The VALUE COLLECTION G180 25 is a Class 150 malleable iron pipe cross designed for threaded pipe assemblies in liquid, gas, and steam distribution systems. The cross configuration provides a four-way junction, allowing a single fitting to branch a run in three directions simultaneously. Rated at 300 psi for liquid and gas service and 150 psi for steam, this fitting suits a wide range of commercial and industrial piping applications. The galvanized finish provides corrosion resistance in moderate-exposure environments. Licensed plumbers and pipefitters are the typical installers for this class of fitting.

This malleable iron cross is suited for use in residential and light commercial plumbing, HVAC hydronic systems, compressed air lines, and gas distribution piping where a threaded four-way connection is required. The 1-inch fitting size fits standard 1-inch threaded pipe. Conformance to ISO 7/1 threading standards ensures compatibility with properly sized tapered pipe threads throughout the assembly.

Key Features

• 300 psi liquid and gas pressure rating for demanding service conditions
• 150 psi steam pressure rating suitable for low-pressure steam piping
• Malleable iron construction provides strength and resistance to impact compared to cast iron
• Galvanized finish adds corrosion resistance for extended service life
• Threaded end connections conform to ISO 7/1 standards
• Class 150 fitting suitable for a broad range of standard piping systems

Compatibility

Designed as an OEM-style replacement or new-installation fitting for standard 1-inch threaded malleable iron pipe systems in plumbing, HVAC, gas, and steam applications.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local codes and the International Plumbing Code or International Fuel Gas Code as relevant. Shut off and depressurize the supply line completely before disassembling or installing threaded fittings. Apply an appropriate thread sealant or PTFE tape to male threads before assembly. Do not over-tighten, as malleable iron fittings can crack under excessive torque.