Value Collection G130 15 Malleable Iron Pipe Tee 1/2 in

Product Description

The VALUE COLLECTION G130 15 is a Class 150 malleable iron pipe tee designed for threaded pipe assemblies in plumbing, HVAC, and industrial piping systems. This fitting accepts 1/2-inch threaded connections and handles liquid and gas service up to 300 psi and steam service up to 150 psi. The galvanized finish provides corrosion resistance for use in a wide range of piping environments. A standard tee configuration allows a branch takeoff perpendicular to the main run, making it a common component in distribution and supply piping layouts. Licensed plumbers and pipefitters are the primary installers of this fitting.

This malleable iron tee is suited for residential and light commercial piping applications involving water, gas, air, and steam distribution. It meets ISO 7/1 threading standards, ensuring compatibility with standard tapered pipe threads found throughout North American and international piping systems. Typical install scenarios include branch connections in supply lines, gas distribution headers, and steam piping at or below 150 psi. The galvanized coating makes it appropriate for exposed or mildly corrosive service environments.

Key Features

• 300 psi liquid and gas pressure rating for demanding service conditions
• 150 psi steam pressure rating suitable for low-pressure steam systems
• Threaded end connections conforming to ISO 7/1 tapered pipe thread standard
• Galvanized finish for corrosion resistance in exposed or wet environments
• Class 150 malleable iron construction for durability and machinability
• 1/2-inch fitting size fits standard half-inch threaded pipe runs

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 1/2-inch threaded pipe systems in plumbing, gas, and steam distribution applications meeting Class 150 service requirements.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local codes, including IPC and IFGC requirements where gas service is involved. Shut off and depressurize the system fully before removing or installing any threaded fittings. Apply an appropriate thread sealant or PTFE tape to male threads before assembly, and tighten to snug plus a wrench-turn without over-stressing the fitting. Inspect for leaks after restoring system pressure.