Value Collection FWI5050-050BX Structural Flat Washer 50 Pack

Product Description

The VALUE COLLECTION FWI5050-050BX is a structural flat washer designed for use with 1/2 inch fasteners in load-bearing and structural bolted connections. Made from steel with a plain finish, this washer meets ASTM F436 standards, making it appropriate for structural steel applications where consistent load distribution and clamping force are required. The 17/32 inch inside diameter fits cleanly over a 1/2 inch bolt shank, while the 1-1/16 inch outside diameter spreads load across the bearing surface. This box contains 50 washers. Ironworkers, structural steel erectors, and general contractors commonly specify this washer for steel-to-steel connections in commercial and industrial construction.

This washer is suited for structural bolted assemblies in both new construction and retrofit applications. Typical use cases include steel beam connections, column base plates, and other load-bearing steel frame joints where ASTM F436 compliance is required by specification or code. The plain finish is standard for interior and protected structural applications. Because these ship in minimum quantities of 50, they are well suited to contractors and fabricators who need consistent stock on hand for ongoing structural work.

Key Features

• Meets ASTM F436 fastener standard for structural applications
• 17/32 inch inside diameter fits 1/2 inch bolt shanks
• 1-1/16 inch outside diameter for broad load distribution
• Steel construction with plain finish
• Material grade 1035/1050 steel for structural-grade strength
• Sold in a 50-piece pack to support job-site and shop inventory needs

Compatibility

Designed as an ASTM F436-compliant structural flat washer for use with 1/2 inch screw and bolt fasteners in steel structural assemblies.

Installation Notes

Installation is typically performed by ironworkers, structural steel erectors, or licensed contractors working under applicable structural and building codes. Always de-energize any nearby electrical systems and follow site safety protocols before working in structural steel areas. Washers should be installed with the flat bearing face seated squarely against the connected material. Torque requirements are determined by the applicable connection specification and are not provided here.