Value Collection DPBFI0-60100P-500BX Drywall Screw 1in 6

Product Description

The VALUE COLLECTION DPBFI0-60100P-500BX is a Number 6 coarse-thread drywall screw designed for fastening gypsum board to wood framing or light steel studs. At 1 inch in overall length, this screw suits single-layer drywall installations where a low-profile fastener is needed. The bugle head countersinks cleanly into drywall paper without tearing the surface, and the Phillips drive allows consistent torque control with a standard screw gun or drill driver. The black phosphate finish reduces corrosion during installation and provides better joint compound adhesion. Each box contains 500 screws, sized for job-site use by drywall hangers and finish carpenters.

This screw is well suited for residential and light commercial drywall applications. The 1-inch length is commonly used for fastening 1/2-inch or 5/8-inch gypsum panels to wood studs or for attaching drywall to light-gauge steel framing. The Grade 2 steel construction provides adequate shear strength for standard interior partition walls and ceilings. These screws are typically installed with a drywall screw gun set to a consistent depth stop to achieve proper countersink depth without breaking the face paper.

Key Features

• Bugle head profile countersinks flush without tearing drywall paper
• Phillips drive compatible with standard drywall screw guns and drill drivers
• Black phosphate finish improves corrosion resistance and joint compound adhesion
• Grade 2 steel construction suitable for standard interior drywall fastening
• 1 inch overall length sized for single-layer 1/2-inch and 5/8-inch gypsum panel installations
• Sold in a box of 500 for job-site volume use

Compatibility

Designed as a standard Number 6 bugle-head drywall screw for use with 1/2-inch or 5/8-inch gypsum wallboard panels fastened to wood or light-gauge steel framing members.

Installation Notes

Installation is performed by drywall hangers or finish carpenters using a drywall screw gun with an adjustable depth-stop clutch. Set the clutch depth so the screw head sits just below the drywall surface without breaking the paper facing. Follow local building codes and manufacturer spacing requirements for fastener layout on walls and ceilings. Do not overdrive screws, as breaking the face paper reduces holding strength and requires additional patching.