Value Collection CD552570 Standard Clevis Pin 0.5 in

Product Description

The VALUE COLLECTION CD552570 is a standard clevis pin made from zinc-plated steel, designed for use in mechanical linkage assemblies, cotter pin connections, and load-bearing pivot applications. The pin measures 0.5 inches in diameter with a 2-inch overall length and a 1-27/32-inch usable length, providing a reliable fit in standard clevis and yoke assemblies. A 9/64-inch cross-hole is drilled near the retention end to accept a cotter pin or snap ring. The zinc plating provides basic corrosion resistance for general-purpose use in dry or mildly humid environments. Machinists, millwrights, and maintenance technicians install this type of hardware across a wide range of industrial and mechanical applications.

This clevis pin is suited for use in linkage rods, hydraulic cylinder ends, chain connectors, hitch assemblies, and control rod pivot points. It fits standard clevis brackets and yokes dimensioned for a 0.5-inch pin bore. The 9/64-inch cotter pin hole allows secure retention with a standard cotter pin or hitch pin clip. Typical applications span light industrial equipment, agricultural machinery, material handling systems, and general MRO maintenance work where a reliable, off-the-shelf clevis pin is required.

Key Features

• 0.5-inch pin diameter fits standard clevis and yoke assemblies dimensioned for 1/2-inch pin bores
• 2-inch overall length with 1-27/32-inch usable length for proper engagement in typical linkage hardware
• 9/64-inch retention hole accepts standard cotter pins or hitch pin clips
• Zinc-plated steel construction provides general-purpose corrosion resistance
• Standard geometry suitable for a wide range of MRO, industrial, and mechanical linkage applications

Compatibility

Designed as a standard-geometry clevis pin for use in clevis brackets, yokes, and linkage assemblies with a 0.5-inch pin bore and clearance for a 2-inch overall length pin.

Installation Notes

Installation is typically performed by maintenance technicians or millwrights as part of mechanical linkage assembly or repair. Ensure the mating clevis or yoke bore is clean and free of debris before inserting the pin. Always secure the pin with an appropriately sized cotter pin or clip through the 9/64-inch retention hole to prevent walk-out under load or vibration. Do not use this pin in applications exceeding its rated load capacity or in highly corrosive environments where zinc plating alone is insufficient protection.