Value Collection CA7045U41 Cut-off Wheel 7 in Aluminum Oxide

Product Description

The VALUE COLLECTION CA7045U41 is a Type 1 (01/41) flat-profile cut-off wheel designed for aggressive material removal on steel. It measures 7 inches in diameter with a 1/16-inch cutting thickness and a 5/8-inch arbor hole. The wheel is constructed from aluminum oxide abrasive bonded with a resinoid bond and reinforced for added structural integrity during high-speed operation. Rated to a maximum of 8500 RPM, it carries an A46T specification and a hardness code of T. This wheel is sized for use with circular saws and angle grinders equipped with a compatible arbor. It is suited for trades work where clean, efficient cuts on ferrous steel are required.

This cut-off wheel is intended for cutting steel in trade and industrial settings. The 46-grit rating provides a balance of cut speed and surface finish appropriate for structural steel, pipe, sheet metal, and similar ferrous stock. Its Type 1 flat profile makes it the standard configuration for straight cut-off applications. HVAC, plumbing, electrical, and general mechanical contractors will find this wheel appropriate for daily shop and field cutting tasks where a 7-inch circular saw or compatible grinder is in use.

Key Features

• Aluminum oxide abrasive with resinoid bond for consistent cut performance on steel
• Reinforced construction supports high-speed operation up to 8500 RPM
• 1/16-inch cutting width minimizes material loss during straight cuts
• Type 1 (01/41) flat-profile geometry for standard cut-off applications
• 5/8-inch arbor hole fits common circular saws and angle grinders
• A46T specification with hardness code T for ferrous steel cutting

Compatibility

Designed for use with circular saws and compatible power tools fitted with a 5/8-inch arbor. Rated for ferrous steel applications per the A46T specification.

Installation Notes

This wheel should be installed and operated by personnel familiar with abrasive wheel safety practices. Always verify the tool spindle speed does not exceed the 8500 RPM maximum rating before mounting. Inspect the wheel for cracks or chips before each use and never operate a damaged wheel. Follow ANSI B7.1 safety code requirements for the mounting, guarding, and use of abrasive wheels.