Value Collection CA6045U41 Cut-off Wheel 6 in Aluminum Oxide

Product Description

The VALUE COLLECTION CA6045U41 is a Type 1 (01/41) aluminum oxide cut-off wheel designed for straight cutting applications on steel. At 6 inches in diameter and 1/16 inches thick, this reinforced wheel delivers fast, controlled cuts with minimal material loss. The 46-grit aluminum oxide abrasive is bonded with a resinoid bond and carries a hardness code of T, providing consistent cutting performance across flat and structural steel stock. Rated to a maximum of 10,200 RPM, the wheel is suitable for use with circular saws and compatible right-angle grinders. It ships as a single unit and is a practical consumable for trade and industrial cutting tasks.

This cut-off wheel is intended for ferrous metal cutting, specifically steel, in trade and light industrial settings. Typical applications include cutting pipe, angle iron, flat bar, and structural steel sections. The 5/8-inch arbor hole fits standard circular saw and grinder spindles common in fabrication, mechanical contracting, and general construction environments. Its thin 1/16-inch kerf reduces heat buildup and minimizes burr formation at the cut line. The wheel is well-suited for HVAC duct work framing, plumbing rough-in steel support fabrication, and general mechanical trade cutting tasks.

Key Features

• 6-inch diameter Type 1 flat wheel profile for straight, controlled cuts
• 1/16-inch thickness reduces kerf width and heat generation during cutting
• 46-grit aluminum oxide abrasive with resinoid bond rated hardness T
• 10,200 RPM maximum speed rating for safe use with circular saws and angle grinders
• 5/8-inch arbor hole fits standard tool spindles
• Reinforced construction with A46T US specification for consistent wheel integrity

Compatibility

Designed for use with circular saws and angle grinders accepting a 5/8-inch arbor hole and operating within the 10,200 RPM maximum speed rating. Rated for cutting steel per the A46T US specification.

Installation Notes

Install and service abrasive cut-off wheels only when the tool is fully powered down and unplugged or locked out per OSHA lockout/tagout procedures. Verify that the tool spindle speed does not exceed the 10,200 RPM maximum rating stamped on the wheel before mounting. Inspect the wheel for cracks, chips, or damage prior to each use and never use a damaged wheel. Always use the appropriate guard for the tool and wear face protection rated for abrasive wheel operations.