Value Collection CA6025U61 Cut-off Wheel 6 in Aluminum Oxide

Product Description

The VALUE COLLECTION CA6025U61 is a Type 1 flat cut-off wheel designed for cutting steel and ferrous metals in demanding trade and shop environments. Built with aluminum oxide abrasive and a resinoid bond, it delivers consistent stock removal on hard materials. The wheel measures 6 inches in diameter and 1/32 inch thick, with a 5/8 inch arbor hole. At 60 grit and rated to 10,186 RPM, it suits applications requiring a controlled cut on carbon steel, structural steel, and similar workpieces. A reinforced construction adds resistance to shattering during lateral stress, a critical safety factor for high-speed cutting tools.

This cut-off wheel is intended for use with circular saws and compatible stationary or portable abrasive cutting equipment that accepts a 5/8 inch arbor and operates within the 10,186 RPM maximum. It fits typical applications in metal fabrication, plumbing rough-in, HVAC duct and pipe work, electrical conduit cutting, and general maintenance where clean, repeatable cuts on steel are required. The 6 inch diameter and thin 1/32 inch kerf minimize material loss and heat buildup during the cut.

Key Features

• Aluminum oxide abrasive with resinoid bond for consistent cutting on steel
• Reinforced Type 1 (01/41) flat wheel construction resists shattering under load
• 60 grit formulation balances cut speed and surface finish on ferrous metals
• 10,186 RPM maximum speed rating for safe use on rated circular saws
• 1/32 inch thin kerf reduces heat and material waste per cut
• 5/8 inch arbor hole fits standard circular saw spindles

Compatibility

Designed for use with circular saws and abrasive cut-off machines that accept a 5/8 inch arbor and support a 6 inch diameter wheel operating at or below 10,186 RPM. Rated for cutting steel per the A60T US specification.

Installation Notes

Installation and use should be performed by qualified tradespeople familiar with abrasive wheel safety practices. Before mounting, verify that the tool spindle speed does not exceed the 10,186 RPM maximum stamped on the wheel. Inspect the wheel for cracks or chips before each use and never use a damaged wheel. Always use the appropriate arbor flange and guard per the tool manufacturer requirements and applicable ANSI B7.1 safety standards.