Value Collection C625144 8-32 X 3/8 Truss Head Phillips Screw

Product Description

The VALUE COLLECTION C625144 is an 8-32 machine screw with a truss head and Phillips drive, manufactured from grade 18-8 stainless steel with a bright, uncoated finish. The truss head profile offers a wide, low-domed bearing surface suited for securing thin materials or components where a standard pan or flat head may not distribute load as effectively. At 3/8 inches in length measured under the head, this screw is sized for shallow fastening applications. The 18-8 stainless steel construction provides corrosion resistance in both indoor and light outdoor environments. These screws are sold in lots of 100 units per order.

This fastener is well suited for light mechanical assembly, electrical enclosure work, panel mounting, and general trade applications where corrosion resistance is required. The 8-32 unified coarse thread is one of the most common thread sizes across HVAC equipment panels, electrical boxes, and control enclosures. The Phillips drive is compatible with standard screwdrivers and bit-driver tools commonly found on any service vehicle. Installation is straightforward in pre-tapped holes or with a matching 8-32 nut.

Key Features

• 8-32 unified coarse thread for broad compatibility with pre-tapped holes and standard hardware
• Truss head profile provides a wide bearing surface with low-profile dome
• Phillips drive accepts standard No. 2 Phillips screwdrivers and bit drivers
• Grade 18-8 stainless steel construction for corrosion resistance
• Bright, uncoated finish — no plating to chip or flake in service
• 3/8 inch length under head for shallow-clearance fastening applications

Compatibility

Designed as a general-purpose 8-32 machine screw for use in pre-tapped holes or with standard 8-32 nuts across mechanical, electrical, and HVAC panel assembly applications.

Installation Notes

Install into a clean, properly tapped 8-32 hole using a No. 2 Phillips screwdriver or matching power-driver bit. Avoid overtightening stainless fasteners, as 18-8 stainless is susceptible to galling when driven at high torque into stainless tapped holes — apply thread lubricant if mating material is also stainless. Power down any electrical enclosure or control panel before fastening work in live equipment. Minimum order quantity is 100 pieces per purchase.