Value Collection C52000436 No. 8 Hex Washer Screw

Product Description

The VALUE COLLECTION C52000436 is a No. 8 hex washer head sheet metal screw designed for fastening thin metal panels, ductwork, junction boxes, and similar light-gauge metal assemblies. The slotted drive accepts a standard flat-blade screwdriver or slotted bit. At 0.5 inches in length under the head, this screw is suited for shallow-material applications where a short fastener is required. The self-piercing point eliminates the need for a pilot hole in light-gauge sheet metal. Finished in zinc for basic corrosion resistance, the steel construction provides reliable holding strength in dry indoor installations.

This screw is commonly used in HVAC duct fabrication and assembly, electrical enclosure work, and general sheet metal fastening tasks. Typical applications include securing sheet metal panels, attaching duct covers, fastening electrical box knockouts, and other light-gauge metal joining work encountered in residential and commercial mechanical and electrical installations. The hex washer head provides a broad bearing surface and allows both a hex-driver and slotted bit to be used, offering flexibility in the field.

Key Features

• Self-piercing point drives into light-gauge sheet metal without a pre-drilled pilot hole
• Hex washer head accepts a hex driver or flat-blade slotted bit
• Zinc finish provides basic corrosion resistance for indoor applications
• Steel construction delivers consistent thread engagement in sheet metal
• 0.5-inch length under head suits shallow-material fastening applications
• No. 8 thread size is a standard gauge for HVAC and sheet metal work

Compatibility

Designed as a standard No. 8 sheet metal screw for use with light-gauge steel panels, ductwork, and enclosures common in HVAC, electrical, and plumbing trade applications.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and plumbers as part of duct assembly, panel fastening, and enclosure work. No pilot hole is required for light-gauge material due to the self-piercing point; for heavier gauges, pre-drilling may be necessary. Use a properly sized slotted bit or hex driver to avoid cam-out and head damage. Follow applicable local mechanical and electrical codes for fastener requirements in specific assemblies.