Value Collection C50000382 Self Drilling Screw 50 Pack

Product Description

The VALUE COLLECTION C50000382 is a 1/4 inch self drilling screw designed for fast, reliable fastening without a pre-drilled pilot hole. Featuring a hex washer head and hex drive, this screw seats flush and resists cam-out under power tool use. The 1 inch length under head makes it suitable for light-gauge metal-to-metal and metal-to-substrate applications. Constructed from steel with a zinc-plated finish, it resists corrosion in typical interior and light exterior environments. Sold in a pack of 50, this screw is a practical stocking option for contractors and service technicians who need consistent hardware on hand.

This screw is used in a wide range of trade applications including HVAC ductwork assembly, metal framing, electrical enclosure mounting, and general sheet metal fabrication. The number 3 drill point is suited for self-tapping into light-gauge steel without pre-drilling. It is appropriate for both residential and light commercial work wherever a 1/4 inch hex washer head fastener is specified. The hex drive accepts standard 1/4 inch hex-shank nut drivers and impact drivers commonly found on any job site.

Key Features

• Number 3 drill point self-taps into light-gauge steel without a pilot hole
• Hex washer head provides a broad bearing surface and resists pull-through
• Hex drive compatible with standard 1/4 inch nut drivers and impact drivers
• 1 inch length under head suits typical sheet metal and light structural applications
• Zinc-plated steel construction provides corrosion resistance for interior and light exterior use
• Pack of 50 supports stocking and bulk job-site use

Compatibility

Designed as a standard 1/4 inch hex washer head self drilling screw for general light-gauge metal fastening applications across HVAC, electrical, and metal framing trades.

Installation Notes

Install with a 1/4 inch hex-shank nut driver or impact driver set to an appropriate clutch setting to avoid overdriving and stripping the material. Ensure the substrate material thickness is within the rated capacity of a number 3 drill point before use. Do not use on hardened steel or substrates that exceed the drill point rating. Follow applicable building codes and manufacturer specifications for fastener spacing and pull-out requirements.