Value Collection C13008 No. 4 Pan Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION C13008 is a No. 4 pan head Phillips drive sheet metal screw designed for fastening light-gauge sheet metal, HVAC ductwork, electrical enclosures, and similar thin-material assemblies. Each screw measures 3/4 inches in length under the head and features a Type AB point for self-starting entry into pre-punched or pre-drilled sheet metal. Made from Grade 2 steel with a zinc finish for basic corrosion resistance, these screws are a standard consumable for HVAC technicians, electricians, and sheet metal workers. This listing covers a pack of 100 screws.

These screws are well-suited for light commercial and residential applications where No. 4 fasteners are specified. Typical uses include securing HVAC duct sections, attaching access panels, fastening electrical junction box covers, and general sheet metal assembly work. The pan head profile provides a broad bearing surface that resists pull-through on thin-gauge material, and the Phillips drive is compatible with standard power drivers and hand screwdrivers commonly found on any service truck.

Key Features

• No. 4 thread size suits light-gauge sheet metal fastening applications
• 3/4 inch length under head for standard sheet metal thickness overlap
• Type AB point self-starts in pre-punched or pre-drilled holes without a pilot
• Pan head profile distributes clamping load to reduce pull-through risk
• Grade 2 steel construction with zinc finish for basic corrosion resistance
• 100-piece pack reduces restocking frequency on active job sites

Compatibility

Designed as a standard No. 4 pan head Phillips Type AB sheet metal screw suitable for light-gauge sheet metal assemblies including HVAC ductwork, electrical enclosures, and access panels.

Installation Notes

Installation is performed by HVAC technicians, electricians, and sheet metal mechanics using a Phillips bit and power driver or hand screwdriver. Ensure the mating material is properly supported and that hole size matches the No. 4 thread specification before driving. Do not overtighten, as over-driving into thin-gauge sheet metal can strip the hole or deform the material. Follow applicable codes such as SMACNA duct construction standards when fastening HVAC duct sections.