Value Collection BOEC14200wHex Elevator Bolt 1/4-20

Product Description

The VALUE COLLECTION BOEC14200wHex is a 1/4-20 UNC elevator bolt designed for conveyor, agricultural, and material-handling assemblies where a flat, low-profile head must seat flush against a belt or wooden member. The bolt is manufactured from Grade 2 steel in an uncoated finish and measures 2 inches in length under the head. The flat head diameter ranges from 0.9690 to 1.0080 inches (nominal 31/32 inches), providing a broad bearing surface that resists pull-through in softer substrates. Mechanics, millwrights, and maintenance technicians working on conveyor lines are the primary installers of this fastener.

Elevator bolts are commonly used in bucket elevator systems, flat belt conveyors, grain handling equipment, and similar agricultural or industrial machinery. The flat head profile sits flush or slightly recessed into the belt or board, keeping the running surface clear of protrusions that could snag material or damage the belt. This bolt is sold in minimum order quantities of 100 units, making it suited for production maintenance operations that require on-hand stock of a consistent fastener size.

Key Features

• 1/4-20 UNC thread for compatibility with standard inch-series nuts and hardware
• Flat head design provides a low-profile, flush-mount bearing surface
• Head diameter 0.9690 to 1.0080 inches for secure pull-through resistance
• 2-inch length under head suits standard belt and board thicknesses
• Grade 2 steel construction for general-purpose mechanical applications
• Uncoated finish — field coating or plating can be applied after installation as needed

Compatibility

Designed as a standard-configuration replacement elevator bolt for 1/4-20 UNC applications in bucket elevator systems, flat belt conveyors, and agricultural material-handling equipment using Grade 2 inch-series fasteners.

Installation Notes

Installation is typically performed by millwrights or maintenance mechanics using standard hand tools and a torque wrench sized for 1/4-inch fasteners. Power down and de-energize all conveyor or elevator drive systems and follow applicable lockout/tagout procedures before removing or installing belt fasteners. Ensure the mating surface is clean and flat so the head seats fully without rocking. Pair with an appropriate Grade 2 or higher hex nut and flat washer on the back side of the belt or board.