Value Collection BDNA-32796 Beveled Square Washer 7/8 Bolt

Product Description

The VALUE COLLECTION BDNA-32796 is a beveled square washer machined from low carbon steel, designed to distribute load evenly across bolted connections on structural and mechanical assemblies. The beveled profile compensates for angled or irregular mating surfaces, ensuring uniform clamping force where a standard flat washer would not seat properly. Sized for a 7/8-inch bolt with a 15/16-inch inside diameter and a minimum thickness of 9/16 inches, this washer is a reliable hardware solution for contractors, ironworkers, and maintenance technicians working on structural steel, timber framing, or heavy equipment installations.

Beveled square washers of this type are commonly used in structural steel connections, wood-to-steel fastening applications, and beam-to-column joints where tapered flanges or sloped surfaces require a compensating bearing surface. They are a standard component in commercial and industrial construction projects and are also used in heavy equipment fabrication and repair where bolt alignment over non-parallel surfaces is required. Licensed tradespeople and experienced general contractors are the typical installers.

Key Features

• Beveled profile seats flush on angled or tapered surfaces for consistent load distribution
• Low carbon steel construction provides adequate ductility and strength for structural fastening applications
• 7/8-inch bolt size compatibility suits common structural fastener standards
• 15/16-inch inside diameter provides proper clearance for 7/8-inch bolt shanks
• 9/16-inch minimum thickness supports substantial clamping loads without deformation
• Square outer profile resists rotation and provides a broad bearing footprint on framing members

Compatibility

Designed as a standard beveled square washer for use with 7/8-inch fasteners in structural steel and heavy timber framing applications.

Installation Notes

Installation is typically performed by ironworkers, structural carpenters, or mechanical maintenance technicians. Always torque fasteners to the specification required by the applicable structural or mechanical standard for the joint being assembled. Inspect the washer seating surface before tightening to confirm the bevel is oriented correctly against the tapered flange or angled surface. Follow applicable building code and structural engineering requirements when using beveled washers in load-bearing connections.