Value Collection BDNA-32678 Wire Rope Clip 1/2 in

Product Description

The VALUE COLLECTION BDNA-32678 is a forged steel wire rope clip designed to secure wire rope ends and form load-bearing loops, eyes, or connections in rigging, lifting, and tie-down applications. Finished with a mechanically galvanized coating for corrosion resistance, this clip is sized for 1/2-inch diameter wire rope. Forged construction provides the structural integrity required for demanding industrial and trade environments. Installation follows standard U-bolt clip orientation practices to achieve rated holding capacity. Riggers, maintenance technicians, and trade professionals working with wire rope assemblies will find this a straightforward, code-compatible fastening component.

This wire rope clip is suited for use in industrial rigging, material handling, construction, and marine tie-down scenarios where 1/2-inch wire rope terminations are required. It is appropriate for both permanent and temporary wire rope end connections where a mechanically galvanized finish provides adequate environmental protection. Typical applications include eye loop formation, thimble terminations, and dead-end anchoring of wire rope in general-purpose rigging setups.

Key Features

• Forged steel construction for high structural strength in rigging and lifting applications
• Mechanically galvanized finish provides corrosion resistance in outdoor and industrial environments
• Sized for 1/2-inch diameter wire rope
• Standard U-bolt clip design compatible with common rigging hardware and thimbles
• Compact form factor suitable for use in tight rigging assemblies

Compatibility

Designed as a standard-pattern wire rope clip for use with 1/2-inch diameter wire rope in general-purpose rigging, lifting, and tie-down assemblies.

Installation Notes

Installation should be performed by a qualified rigger or tradesperson familiar with wire rope termination practices and applicable ASME or OSHA rigging standards. Always orient the U-bolt over the dead end of the rope and the saddle over the live load-bearing end — never saddle a dead horse. Apply the correct number of clips as specified by wire rope manufacturer guidelines for the rope diameter and ensure all nuts are torqued evenly. Inspect the assembly after initial loading and re-tighten as needed per standard rigging inspection procedures.