Value Collection BDNA--24127-7 Worm Gear Clamp Sae 96

Product Description

The VALUE COLLECTION BDNA--24127-7 is a worm drive (worm gear) hose clamp rated SAE Size 96, designed to secure hoses, ducts, and fittings in plumbing, HVAC, and general mechanical applications. The clamp features a stainless steel band that is 0.5 inches wide and adjusts to fit diameters from 5-5/8 inches up to 6-1/2 inches. The worm drive mechanism allows precise tightening with a standard screwdriver or nut driver, providing consistent radial pressure around the hose or duct connection. Plumbers, HVAC technicians, and mechanical contractors install this type of clamp during new construction and service work alike.

This clamp is suited for residential and light commercial installations where a corrosion-resistant fastener is required. Typical applications include securing flexible duct connectors, radiator hoses, coolant lines, irrigation fittings, and other round hose or sleeve connections in the 5-5/8 inch to 6-1/2 inch diameter range. The stainless steel construction makes it appropriate for environments with moisture exposure or mild chemical contact.

Key Features

• SAE Size 96 worm drive clamp with an adjustment range of 5-5/8 inches to 6-1/2 inches diameter
• Stainless steel band and housing for corrosion resistance in wet or outdoor environments
• Band width of 0.5 inches distributes clamping load evenly around the hose or fitting
• Worm drive mechanism accepts standard flat-blade or hex nut driver for quick tightening
• Lightweight at 0.01 pounds, suitable for overhead or confined-space installations

Compatibility

Designed as a standard SAE 96 worm gear clamp for use with hoses, flexible ducts, and fittings in the 5-5/8 inch to 6-1/2 inch outside diameter range across plumbing, HVAC, and general mechanical applications.

Installation Notes

Installation is performed by plumbers, HVAC technicians, or mechanical contractors using a flat-blade screwdriver or 5/16-inch hex nut driver. Before servicing any pressurized line, shut off the supply and relieve system pressure fully. Position the clamp over the hose or fitting before seating the hose, then tighten the worm drive evenly to avoid distorting the band. Do not overtighten on soft hose materials, as excessive force can cut through the hose wall.