Value Collection BDNA-15825 Copper 90 Elbow 1-1/4 in C X C

Product Description

The VALUE COLLECTION BDNA-15825 is a wrot copper 90-degree elbow fitting designed for use in copper pipe systems. It connects two pipe runs at a right angle using sweat (C x C) end connections on both ends. The fitting measures 1-1/4 inches on each end with an outside diameter of 1-3/8 inches per side. Wrot copper construction provides the dimensional consistency and pressure integrity that licensed plumbers require in residential and light commercial piping installations. This fitting is sweat-joined using standard soldering technique and is suited for potable water, hydronic heating, and general plumbing distribution lines.

This elbow is used in copper pipe installations where a 90-degree directional change is needed in the run. Typical applications include domestic water supply systems, hydronic heating loops, and in-wall or exposed plumbing rough-in work. The C x C (copper-to-copper sweat) connection type makes it compatible with standard Type K, L, and M copper tubing of the same nominal size. Installation is performed by licensed plumbers or qualified plumbing contractors in both new construction and retrofit applications.

Key Features

• Wrot copper construction for consistent wall thickness and reliable sweat joints
• 90-degree elbow geometry for right-angle directional changes in copper pipe runs
• C x C end connections on both ends for standard sweat soldering
• 1-1/4 inches x 1-1/4 inches fitting size with 1-3/8 inches outside diameter per end
• Suitable for potable water, hydronic, and general plumbing distribution applications

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 1-1/4 inch nominal copper pipe systems using C x C sweat connections.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable IPC or local plumbing codes. Shut off and drain the water supply before cutting into an existing line. Clean and flux both the pipe end and fitting socket thoroughly before applying heat and solder. Do not overheat the fitting, as excessive heat can damage the copper and compromise joint integrity.