Value Collection BDNA-15748 Wrot Copper Coupling 1-1/4 in

Product Description

The VALUE COLLECTION BDNA-15748 is a wrot copper pipe coupling designed for 1-1/4 inch copper pipe systems using sweat (C x C) end connections. Wrot copper is wrought from solid copper stock, producing a denser, stronger fitting compared to cast alternatives. The coupling joins two lengths of copper pipe in a straight run and is installed by soldering both ends to the pipe. It is a standard fitment used by licensed plumbers and pipefitters in residential and light commercial plumbing, HVAC hydronic, and refrigeration piping applications.

This coupling is suited for use in potable water supply lines, drain and vent systems where copper is appropriate, and hydronic heating or cooling loops. The C x C end connection requires standard copper tube preparation — cutting, deburring, and flux application — before soldering. The 1-1/4 inch fitting size accommodates pipe with an outside diameter of 1-3/8 inches. It is a single-unit item sold in minimum order quantities of 5.

Key Features

• Wrot copper construction for higher density and pressure integrity compared to cast copper fittings
• C x C (sweat) end connections on both ends for standard soldered joints
• 1-1/4 inch fitting size with a 1-3/8 inch outside diameter
• Straight coupling design for inline pipe joining in continuous runs
• Lightweight at 0.01 pounds per unit, easy to handle and store on the job

Compatibility

Designed as an OEM-style replacement and standard-use fitting compatible with 1-1/4 inch copper pipe systems using sweat-joint connections in residential and commercial plumbing and hydronic applications.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters following applicable IPC and local plumbing code requirements. Shut off and depressurize the water or fluid system completely before cutting into any existing pipe. Prepare pipe ends by cutting square, deburring inside and outside, and applying flux before inserting into the coupling and applying heat with a torch to complete the solder joint. Do not apply heat to a pressurized or wet line.