Value Collection BDNA-15746 Copper Pipe Coupling 3/4 in

Product Description

The VALUE COLLECTION BDNA-15746 is a wrot copper pipe coupling designed for sweat-solder connections in residential and commercial plumbing systems. Configured with a C x C (copper-to-copper) end connection, this 3/4-inch fitting joins two copper pipe runs using standard soldering techniques. Wrot copper construction offers higher strength and pressure resistance compared to cast fittings, making it the preferred choice for pressure lines, domestic water distribution, and hydronic heating applications. Licensed plumbers and pipefitters install this coupling as a standard joining component wherever a continuous copper run must be extended or spliced.

This coupling is suited for 3/4-inch copper pipe installations in residential water supply lines, commercial plumbing rough-in, and hydronic heating loops. The C x C configuration requires a clean-cut pipe end, flux application, and sweat soldering per standard practice. It is commonly specified where wrot copper fittings are required by local code or project spec over cast alternatives. The 7/8-inch outside diameter is consistent with standard 3/4-inch nominal copper tube sizing.

Key Features

• Wrot copper construction for higher tensile strength and pressure integrity compared to cast fittings
• C x C end connections accept standard 3/4-inch copper tubing on both ends
• 7/8-inch outside diameter consistent with nominal 3/4-inch copper tube sizing
• Sweat-solder joint compatible with standard flux and lead-free solder per plumbing codes
• Lightweight at 0.01 pounds, minimizing added load in tight chase or overhead runs

Compatibility

Designed as an OEM-style replacement and standard-use fitting for 3/4-inch nominal copper pipe systems using C x C sweat connections.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local amendments. Shut off the water supply and depressurize the line before cutting or soldering. Clean pipe ends and fitting cups with emery cloth, apply appropriate flux, and solder with a lead-free alloy where required by code. Do not apply heat to a pressurized or water-filled line.