Value Collection BDNA-15634 Wrot Copper Adapter Ftg X M

Product Description

The VALUE COLLECTION BDNA-15634 is a wrot copper pipe adapter designed to connect copper tubing in plumbing and HVAC hydronic systems. The FTG x M end configuration allows a sweat fitting-to-male threaded connection, making it a practical transition fitting for installations where copper tubing meets a threaded male port. Sized at 3/4 inch by 3/4 inch with an outside diameter of 7/8 inch on the fitting end and 3/4 inch on the male end, this adapter is fabricated from wrot copper for reliable, pressure-rated sweat joints. Plumbers and pipefitters install this fitting using standard torch-and-solder methods per applicable codes.

This adapter is suited for residential and light commercial plumbing rough-in work, hydronic heating systems, and HVAC refrigerant-side or water-side piping where a 3/4 inch FTG-to-male threaded transition is required. The wrot copper construction makes it appropriate for potable water, hydronic, and general copper piping applications. It is sold individually with a minimum order quantity of 2 units per order.

Key Features

• Wrot copper construction for clean, strong sweat solder joints
• FTG x M end connection for fitting-to-male threaded transitions
• 3/4 inch by 3/4 inch fitting size for standard copper piping runs
• Outside diameter of 7/8 inch on FTG end and 3/4 inch on male end
• Compact form factor suitable for tight installation spaces

Compatibility

Designed as an OEM-style replacement and standard fitting for 3/4 inch copper piping systems using FTG x M threaded transitions in plumbing and HVAC applications.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter following applicable IPC and local plumbing code requirements. Shut off and depressurize the water or fluid system before cutting into existing lines. Use appropriate flux, solder, and a properly sized torch for sweat connections; ensure fittings and tubing are clean and dry before soldering. Thread connections should be made with appropriate thread sealant per manufacturer and code guidance.