Value Collection BDNA-15607 Copper Pipe Adapter 1/2x3/4 Cxm

Product Description

The VALUE COLLECTION BDNA-15607 is a wrot copper pipe adapter designed to connect a 1/2-inch copper tube (sweat end) to a 3/4-inch male threaded fitting. Wrot copper is wrought — meaning it is formed from solid copper stock — which gives it higher density and greater pressure resistance compared to cast fittings. This adapter is used in potable water supply lines, hydronic heating systems, and general plumbing distribution where a transition from a soldered copper connection to a male NPT threaded joint is required. Licensed plumbers and pipefitters are the typical installers of this component.

This adapter suits residential and light commercial plumbing applications where a sweat-to-male-thread transition is needed. The C x M end configuration means the 1/2-inch end accepts a copper tube soldered into the fitting (cup end), while the 3/4-inch end is a male threaded outlet. It is commonly installed at fixture supply connections, valve inlets, and equipment tie-ins where copper tubing terminates at a threaded port.

Key Features

• Wrot copper construction for high-density, pressure-rated performance in plumbing systems
• C x M end connection: 1/2-inch sweat cup inlet to 3/4-inch male threaded outlet
• Outside diameters of 5/8 inch and 3/4 inch at respective ends
• Compact form factor suitable for tight installation spaces
• Compatible with standard lead-free solder and thread sealant requirements per local plumbing codes

Compatibility

Designed as an OEM-style replacement or new-installation fitting for residential and commercial copper plumbing systems requiring a 1/2-inch sweat to 3/4-inch male threaded adapter.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Shut off the water supply and depressurize the line before soldering. Use lead-free solder and flux on the sweat end, and apply appropriate thread sealant or PTFE tape to the male threaded outlet before making the threaded connection. Do not overheat the fitting during soldering, as excessive heat can compromise the copper material.