Value Collection BDKP26355 Heat Shrink Sleeve Blue

Product Description

The VALUE COLLECTION BDKP26355 is a heat shrink sleeve used to insulate, protect, and bundle wire terminations and cable assemblies. It starts at 0.25 inches inside diameter before shrinking and measures 6 inches in overall length. When heat is applied with a heat gun, the tubing constricts tightly around the substrate, forming a secure insulating layer. Blue color allows quick visual identification during installation or inspection. Electricians, low-voltage technicians, and cable assembly installers use this sleeve in panel wiring, harness fabrication, and field termination work.

This sleeve fits standard wire gauges and connector bodies that fall within the 0.25-inch pre-shrink inside diameter range. At 6 inches in length, it accommodates splices, butt connectors, and terminal ends where a longer coverage zone is needed. Suitable for residential, commercial, and light industrial electrical applications. Sold individually, with a minimum order quantity of 6 pieces per order.

Key Features

• 0.25-inch inside diameter before shrinking accommodates a range of wire gauges and connectors
• 6-inch overall length provides extended coverage for splices and terminal areas
• Blue color aids quick visual identification in multi-circuit wiring work
• Heat shrink construction forms a snug, insulating fit when activated with a heat gun
• Lightweight at 0.01 pounds, with minimal bulk added to the assembly

Compatibility

Designed as a general-purpose heat shrink sleeve for use on wire splices, butt connectors, and terminal ends that fall within the 0.25-inch pre-shrink inside diameter specification.

Installation Notes

Installation is performed by electricians or low-voltage technicians following applicable NEC guidelines. Slide the sleeve over the wire or termination before making the final connection, then apply even heat from a heat gun along the length of the sleeve until it conforms fully. Do not use an open flame, as uncontrolled heat can damage the sleeve or adjacent insulation. Ensure the substrate is clean and dry before applying the sleeve.