Value Collection BDC95990 Heat Shrink Sleeve 6 in Clear

Product Description

The VALUE COLLECTION BDC95990 is a clear heat shrink sleeve designed for insulating, bundling, and protecting wire splices, terminal connections, and cable assemblies. At 6 inches in overall length, this tubing shrinks tightly around conductors when heat is applied, creating a secure, moisture-resistant barrier. It is a standard single-wall heat shrink tube suited for general electrical and low-voltage wiring work. Electricians, HVAC technicians, and panel wiring professionals use this sleeve wherever a clean, insulated finish is needed on spliced or terminated conductors.

This heat shrink sleeve is used across residential, commercial, and light industrial applications. Typical uses include insulating butt splices, covering solder joints, protecting terminal pins, and strain-relieving cable exits from connectors. The clear color allows visual inspection of the underlying conductor or joint after installation. It is commonly used in control wiring, low-voltage signaling circuits, and general electrical repair work.

Key Features

• 6-inch overall length provides coverage for standard splice and termination points
• Clear color allows visual inspection of the joint or conductor beneath
• Heat shrink style conforms tightly to the underlying conductor when heat is applied
• Lightweight construction at 0.01 pounds per piece
• Minimum order quantity of 5 pieces ensures job-site supply availability

Compatibility

Designed as a general-purpose heat shrink sleeve suitable for insulating and protecting wire splices, terminal connections, and cable assemblies in standard electrical and low-voltage wiring applications.

Installation Notes

Heat shrink sleeves are installed by licensed electricians and HVAC technicians as part of wiring and termination work. De-energize and lock out the circuit before making any splice or connection. Slide the sleeve over the conductor prior to making the splice or solder joint, then position it over the finished connection and apply even heat with a heat gun until the sleeve conforms fully. Do not use an open flame, as uneven heat can damage the sleeve or underlying insulation.