Value Collection BDC84025 Heat Shrink Sleeve Blue 24 in

Product Description

The Value Collection BDC84025 is a blue heat shrink sleeve designed for wire insulation, bundling, strain relief, and electrical connection protection. With an inside diameter of 0.25 inches before shrinking and an overall length of 24 inches, this tubing conforms tightly to the underlying surface when heat is applied, creating a durable, insulating barrier. It is commonly used by electricians, HVAC technicians, and general electrical tradespeople to protect splices, terminals, and exposed conductors in light commercial and residential applications. The blue color aids in circuit identification and wire management on the bench or in the field.

This heat shrink sleeve suits a wide range of electrical and electronic wiring tasks where a clean, insulated finish is required. Typical install scenarios include protecting crimped terminals, covering soldered wire joints, and adding strain relief at connector exits. The 24-inch length allows technicians to cut sections to the required length, minimizing waste across multiple connections in a single service call. It is suitable for use in control panels, field wiring harnesses, and low-voltage wiring systems.

Key Features

• 0.25 inch inside diameter before shrinking accommodates small-gauge wire and terminals
• 24 inch overall length can be cut to size for multiple connections from a single piece
• Blue color supports color-coded wire identification in multi-circuit installations
• Heat-activated shrink provides a snug, insulating fit over splices and terminals
• Lightweight construction at 0.01 pounds adds negligible bulk to finished assemblies

Compatibility

Designed as a general-purpose heat shrink sleeve suitable for small-diameter wire insulation and terminal protection in residential and light commercial electrical wiring applications.

Installation Notes

Installation is performed by licensed electricians or qualified technicians following applicable NEC guidelines. De-energize all circuits before applying heat shrink to any conductor or terminal. Slide the sleeve over the wire or joint before making the final connection, then apply a heat gun evenly along the length of the tubing until it conforms fully to the surface. Avoid open-flame heat sources, as uneven heat can damage the sleeve or underlying insulation.