Value Collection BDC423008 Heat Shrink Sleeve 1/8 in 25 Ft

Product Description

The VALUE COLLECTION BDC423008 is a clear heat shrink sleeve designed to protect wire splices, terminals, and electrical connections from moisture, abrasion, and contamination. The tubing starts at 1/8 inch inner diameter before heat is applied, then shrinks down to form a tight, insulating seal over the covered component. At 25 feet in overall length, a single roll provides enough material for a full day of wiring work across multiple connection points. Electricians and HVAC technicians reach for this type of tubing when finishing low-voltage wire bundles, sensor leads, and control wiring on residential and light commercial equipment.

This heat shrink sleeve is suited for electrical and electronics applications where a clean, durable insulating layer is needed over conductors, terminals, or spliced wire runs. Typical install scenarios include control panel wiring, thermostat wire repairs, motor lead insulation, and general wire harnessing. The clear color allows visual inspection of the underlying conductor or splice without removing the sleeve. It is well-suited for both bench work and field installation by licensed electricians, HVAC technicians, and equipment service professionals.

Key Features

• 1/8 inch inner diameter before shrinking for use on small-gauge wire and terminals
• 25 feet of continuous tubing on a single spool for extended use across multiple jobs
• Clear color allows visual inspection of the conductor or splice beneath the sleeve
• Heat-activated shrink provides a snug, abrasion-resistant seal over connections
• Suitable for low-voltage control wiring, sensor leads, and wire harness applications

Compatibility

Designed as a general-purpose heat shrink sleeve suitable for small-gauge wire insulation and terminal protection across electrical, HVAC control wiring, and light commercial service applications.

Installation Notes

Installation is performed by licensed electricians or HVAC technicians following applicable NEC guidelines. De-energize all circuits before applying heat shrink tubing to any live wiring or terminal. Use a heat gun set to the appropriate shrink temperature and apply heat evenly along the length of the sleeve to avoid bubbling or uneven shrinkage. Do not use an open flame to activate the tubing, as uneven heat can damage the sleeve or the underlying conductor insulation.