Value Collection BD9683 Rubber Grommet 9/16 in Od 50 Pack

Product Description

The VALUE COLLECTION BD9683 is a rubber grommet designed to protect wiring, tubing, and cables where they pass through panel cutouts, bulkheads, and sheet metal openings. With a 9/16 inch outer diameter, a 1/4 inch inside diameter, and a 1/16 inch slot width, this grommet seats securely into a standard panel hole and cushions the edge against abrasion. The 11/32 inch slot diameter allows the grommet to snap over wire bundles or individual conductors without requiring a ferrule or additional hardware. Electricians, HVAC technicians, and panel fabricators install this type of grommet as a standard step when routing low-voltage or line-voltage wiring through metal enclosures.

This grommet is suited for light-duty panel work in residential and commercial applications. Common install scenarios include control panel wiring in HVAC equipment, junction box pass-throughs in electrical work, and equipment enclosures where sheet metal edges would otherwise contact insulated conductors. The part is sold in a 50-piece package, making it practical for stocking on a service van or at a shop bench for routine jobs. The rubber construction provides flexibility for insertion and long-term resilience against vibration and temperature cycling typical of mechanical rooms and equipment cabinets.

Key Features

• Rubber material provides flexible installation and edge protection against abrasion
• 9/16 inch outer diameter fits standard panel knockout openings
• 1/4 inch inside diameter accommodates small-gauge wire and tubing
• 11/32 inch slot diameter with 1/16 inch slot width for snap-in wire routing
• 50-piece package supports bench stock and van inventory

Compatibility

Designed as a standard-profile rubber grommet for panel cutouts and bulkhead pass-throughs in electrical, HVAC, and general equipment enclosure applications.

Installation Notes

Installation is performed by electricians or HVAC technicians during panel assembly or service. Power down the circuit or equipment before routing conductors through any enclosure opening. Press the grommet firmly into the panel cutout until the outer flange seats flush against the panel surface on both sides. Inspect the grommet for tears or deformation after seating to confirm the edge is fully protected before pulling wire through.