Value Collection BD3262 Mounted Flap Wheel 60 Grit

Product Description

The VALUE COLLECTION BD3262 is a mounted flap wheel designed for surface blending, deburring, and finishing on metal, wood, and composite materials. The wheel uses aluminum oxide coated abrasive rated at medium grade with a 60 grit designation, providing consistent stock removal without aggressive undercutting. At 1-1/2 inches in diameter with a 1 inch face width and a 1/4 inch shank, it mounts directly into a die grinder or rotary tool and is rated to a maximum of 30,000 RPM. This type of abrasive accessory is standard inventory for machinists, metal fabricators, and tool-and-die shops performing hand-held finishing work.

This mounted flap wheel is suited to applications where a bench grinder or stationary tool cannot reach, including inside bores, curved surfaces, weld seam blending, and contoured workpiece finishing. The 1/4 inch shank fits the collet of most standard die grinders and high-speed rotary tools found in fabrication and maintenance shops. The 60 grit medium grade works well as an intermediate finishing step after rough grinding and before fine polishing stages.

Key Features

• Aluminum oxide coated abrasive for consistent cut rate on ferrous and non-ferrous metals
• 60 grit medium grade suitable for blending, deburring, and light stock removal
• 1/4 inch shank mounts directly to standard die grinders and rotary tools
• 30,000 maximum RPM rating for high-speed rotary tool compatibility
• 1 inch face width provides broad contact on flat and contoured surfaces
• Non-interleaved flap construction for straightforward, uniform abrasion

Compatibility

Designed for use with die grinders and rotary tools accepting a 1/4 inch shank collet. Confirm that the tool spindle speed does not exceed the 30,000 RPM maximum rating of this wheel before use.

Installation Notes

Installation is performed by machinists, fabricators, or maintenance technicians using standard die grinder collet wrenches. Always power down and disconnect or de-energize the rotary tool before mounting or removing the wheel. Verify the tool maximum RPM does not exceed the 30,000 RPM rating marked on this abrasive. Inspect the flap wheel for damage before each use and do not use a wheel that shows torn flaps, cracks, or shank deformation.