Value Collection BD24088 Worm Gear Clamp 1-3/4 to 7 in

Product Description

The VALUE COLLECTION BD24088 is a quick-release worm drive clamp designed for securing hoses, ducts, and fittings across a wide range of pipe and tube diameters. The band spans a minimum diameter of 1-3/4 inches up to a maximum of 7 inches, making it suitable for varied pipe sizes without stocking multiple clamp sizes. The 1/2-inch-wide stainless steel band distributes clamping force evenly and resists corrosion in wet or chemically active environments. Plumbers, HVAC technicians, and general mechanical contractors rely on this type of clamp for drain lines, flex duct connections, radiator hoses, and exhaust couplings.

This clamp is appropriate for residential and light commercial applications wherever a secure, adjustable band connection is required. Its wide diameter range suits large-diameter flexible hose connections found in HVAC flex duct transitions, plumbing drain and waste applications, pool and spa equipment plumbing, and irrigation system fittings. The quick-release worm drive mechanism allows fast installation and removal with a standard hex driver or screwdriver, reducing labor time during service calls or equipment changeouts. Each package contains 10 clamps.

Key Features

• Wide clamping range: 1-3/4 inches minimum to 7 inches maximum diameter
• Stainless steel band and housing for corrosion resistance in wet and outdoor environments
• 1/2-inch band width for even clamping load distribution
• Quick-release worm drive mechanism for fast installation and removal
• Sold in a package of 10 clamps per order unit

Compatibility

Designed as a general-purpose worm gear clamp for hoses, flex duct, and fittings with an outside diameter between 1-3/4 inches and 7 inches across HVAC, plumbing, pool, and mechanical applications.

Installation Notes

Install using a flat-blade screwdriver or 5/16-inch hex driver to tighten the worm drive screw. Shut off fluid flow or de-energize the system before removing or repositioning any existing clamp. Do not overtighten; stop when the hose or fitting is firmly seated without deformation of the material. Installations on potable water or gas-adjacent fittings should comply with applicable IPC or IFGC requirements for mechanical joints.