Value Collection BD23617 Heat Shrink Sleeve 3/32 in Black

Product Description

The VALUE COLLECTION BD23617 is a black heat shrink sleeve designed for insulating, bundling, and protecting wire connections, terminals, and cable splices. With an inside diameter of 3/32 inches before shrinking and an overall length of 6 inches, this tubing applies consistent radial compression when heat is applied, forming a tight, protective layer over the substrate. It is a standard tool in electrical, HVAC controls, and low-voltage wiring work where clean, reliable insulation of conductors is required. Electricians, HVAC technicians, and panel installers use heat shrink sleeving routinely during harness repairs and terminal protection tasks.

This sleeve is suited for residential and light commercial wiring applications where small-gauge conductors, splices, or crimp terminals need environmental and abrasion protection. It fits cleanly over wire gauges appropriate to a 3/32-inch pre-shrink ID. The 6-inch length gives enough material to cover a splice or terminal run without trimming in most standard applications. Minimum order quantity is 10 pieces, with individual package quantity of 1.

Key Features

• Heat shrink construction applies radial compression when heated, sealing around conductors and terminals
• 3/32 inch inside diameter before shrinking fits small-gauge wire and crimp terminal applications
• 6 inch overall length provides adequate coverage for most splice and terminal insulation tasks
• Black color aids visual identification and provides a clean finished appearance in wiring harnesses
• Lightweight at 0.01 pounds, minimizing added bulk on finished wire assemblies

Compatibility

Designed as a general-purpose heat shrink sleeve for use with small-gauge conductors and crimp terminals requiring a 3/32 inch pre-shrink inside diameter in electrical, HVAC controls, and low-voltage wiring applications.

Installation Notes

Installation is performed by licensed electricians or qualified HVAC technicians following applicable NEC guidelines. De-energize all circuits before working on conductors or terminals. Slide the sleeve over the conductor or splice before making the final connection, then apply a heat gun evenly along the length of the sleeve to achieve full shrinkage. Avoid using open flame as a heat source, as uneven heat can damage the sleeve or underlying conductors.