Value Collection BD23554 Heat Shrink Sleeve 0.75 in Id

Product Description

The VALUE COLLECTION BD23554 is a black heat shrink sleeve designed to protect and insulate wire terminations, splices, and connections in electrical installations. With a pre-shrink inside diameter of 0.75 inches and an overall length of 2 inches, this sleeve provides a snug, moisture-resistant barrier once heat is applied. It is compatible with wire gauges ranging from AWG 6 (minimum) to AWG 1 (maximum), making it suitable for heavier-gauge wiring applications. Electricians and electrical service technicians are the primary installers of this sleeve in both residential and commercial wiring projects.

This heat shrink sleeve is used wherever insulated wire protection is needed at termination points, junction splices, or bare conductor repairs. Typical applications include panel wiring, service entrance connections, and branch circuit work where heavier AWG conductors are present. The 2-inch length provides adequate coverage for standard wire end preparations. Its black color is commonly used for phase or ground identification in multi-conductor installations, or wherever a clean, uniform finish is required on larger wire gauges.

Key Features

• Pre-shrink inside diameter of 0.75 inches accommodates heavier AWG wire sizes
• Compatible with wire gauges AWG 1 through AWG 6
• 2-inch overall length suits standard termination and splice coverage
• Black color finish for clean, uniform appearance on wire ends
• Heat shrink construction conforms tightly to conductor after application

Compatibility

Designed as an OEM-style replacement or general-use heat shrink sleeve for electrical wire protection applications on AWG 1 through AWG 6 conductors in residential and commercial installations.

Installation Notes

Installation is performed by qualified electricians. De-energize and lock out the circuit before applying the sleeve to any conductor. Slide the sleeve over the wire end or splice before making the final connection, then apply even heat using an approved heat gun until the sleeve conforms fully to the conductor. Avoid using open flame to shrink the sleeve, as uneven heat can damage insulation integrity.