Value Collection BD23542 Heat Shrink Sleeve 3/8 in Red

Product Description

The VALUE COLLECTION BD23542 is a red heat shrink sleeve designed for insulating, protecting, and bundling electrical wire connections. With an inside diameter of 0.375 inches before shrinking and an overall length of 6 inches, this sleeve fits wire gauges from 8 AWG down to 6 AWG. When heat is applied, the tubing contracts tightly around the conductor or splice, creating a snug, insulating barrier that resists moisture and abrasion. Licensed electricians, HVAC technicians, and other trade professionals use heat shrink sleeves during panel work, field wiring, and equipment service to finish and protect terminations cleanly.

This sleeve is suited for residential and light commercial electrical work wherever a clean, protected wire termination is needed. Typical applications include splicing conductors, covering ring terminals and butt connectors, and protecting exposed wire ends in control panels, junction boxes, and equipment wiring harnesses. The 6-inch length provides enough material to cover most standard splice joints or terminal connections on 6 AWG to 8 AWG wire without trimming.

Key Features

• Inside diameter of 0.375 inches before shrinking accommodates 6 AWG to 8 AWG conductors
• 6-inch overall length suits standard splice and terminal covering applications
• Red color for quick visual identification of wiring circuits or phasing conventions
• Heat shrink construction creates a tight, insulating seal when heat is applied
• Lightweight at 0.01 pounds — easy to carry multiples in a service bag

Compatibility

Designed as a standard heat shrink sleeve for use with 6 AWG to 8 AWG electrical wire and cable in residential and commercial wiring applications.

Installation Notes

Installation is performed by licensed electricians or qualified HVAC and controls technicians. Always de-energize the circuit and verify zero voltage with a meter before working on any termination. Slide the sleeve over the conductor or splice before making the final connection, then apply even heat from a heat gun — working from one end to the other — until the sleeve is fully contracted. Avoid open flame as a heat source, as it can scorch or unevenly shrink the sleeve and damage the conductor insulation.