Value Collection BD-C85866 Male Wire Disconnect 16-14 Awg

Product Description

The VALUE COLLECTION BD-C85866 is a fully insulated male wire disconnect designed for secure, vibration-resistant electrical terminations in control wiring, HVAC equipment, and general low-voltage panel work. The blue nylon insulation sleeve provides full coverage over the barrel and tab connection, protecting against incidental contact and moisture ingress. Rated for 16-14 AWG wire, these disconnects accept a 1/4 inch tab width, making them compatible with standard quick-disconnect terminal strips and spade-style receptacles. Electricians, HVAC technicians, and panel wiring crews use these connectors for fast, reliable crimp-and-push installations where soldering is not practical.

These male disconnects are suited for residential and light commercial applications including furnace control boards, air handler wiring harnesses, thermostat sub-bases, and general electrical panel assemblies. The 1/4 inch tab width is a widely used standard in HVAC and appliance wiring. The blue color coding corresponds to the 16-14 AWG wire gauge range, allowing technicians to quickly confirm correct connector selection during assembly or service. This package contains 50 pieces, appropriate for service van stock or small project runs.

Key Features

• Fully insulated nylon sleeve covers barrel and tab for electrical protection
• Blue insulation color-codes to 16-14 AWG wire range for fast field identification
• 1/4 inch tab width fits standard quick-disconnect receptacles and terminal strips
• Male gender for use with matching female disconnect terminals
• Crimp termination — no soldering required
• 50-piece pack supports service stock or job-site quantities

Compatibility

Designed as a standard crimp-style male quick-disconnect terminal for use with 16-14 AWG copper conductors and 1/4 inch female disconnect receptacles common in HVAC control wiring, appliance harnesses, and low-voltage electrical assemblies.

Installation Notes

Installation is performed by licensed electricians or qualified HVAC technicians. Always de-energize the circuit and confirm voltage absence with a meter before terminating or replacing wire connectors. Use a calibrated ratcheting crimp tool sized for insulated disconnects to ensure a gas-tight crimp; an improper crimp can cause high-resistance connections or pull-out failure. Verify wire gauge falls within the 16-14 AWG rating before crimping to avoid insulation damage or loose termination.