Value Collection BD-18738 Outdoor Extension Cord 250 Ft

Product Description

The VALUE COLLECTION BD-18738 is a 250-foot, 14/3 AWG outdoor extension cord rated for 18 amps at 600 volts. Built to SOW-A/SO cord type specifications, it features three conductors and a black jacket designed to withstand outdoor service conditions. This cord is suited for powering tools, equipment, and machinery in demanding job site environments where a long run is required between a power source and the load. Electricians, contractors, and trade professionals use this cord when fixed wiring is not available or practical and a heavy-duty temporary power solution is needed.

This extension cord is intended for outdoor use in construction, maintenance, and industrial service applications. The 14 AWG, 3-conductor configuration supports general-purpose power tools and equipment operating on standard single-phase circuits. The 250-foot length makes it well suited for large job sites, open-bay facilities, and outdoor work areas where shorter cords fall short. The SOW-A/SO cord type designation indicates a flexible, oil-resistant jacket appropriate for ground-level and outdoor deployment.

Key Features

• 250-foot length provides extended reach for large or spread-out job sites
• 14 AWG, 3-conductor (14/3) construction supports 18-amp continuous load capacity
• 600-volt rating accommodates standard single-phase power tool and equipment circuits
• SOW-A/SO cord type features a flexible, oil-resistant jacket rated for outdoor use
• UL Listed and CSA Listed; MSHA Acceptable for mine and industrial site compliance
• Black jacket finish resists visibility issues and blends with typical job site environments

Compatibility

Designed as a general-purpose outdoor extension cord for use with power tools, compressors, lighting, and other 18-amp-rated equipment operating on 600-volt or lower single-phase circuits in outdoor and industrial settings.

Installation Notes

Extension cords of this type are installed by electricians and general contractors as temporary wiring solutions in accordance with NEC Article 400. Inspect the cord jacket for cuts, abrasions, or damage before each use, and do not operate with a damaged jacket. Always de-energize the source circuit before connecting or disconnecting the cord under load. Do not daisy-chain or coil tightly during use, as heat buildup in a coiled cord can reduce safe ampacity.