Value Collection BD-17746 Steel Cable Clamp 25 Pack

Product Description

The VALUE COLLECTION BD-17746 is a steel cable clamp designed to secure and organize wire bundles in electrical, HVAC, and mechanical installations. Built for fastener-mount applications, this clamp accommodates bundles up to 0.25 inches in diameter and uses a 0.25 inch mounting hole for panel or surface attachment. The clamp body is 0.5 inches wide and constructed from steel with a black finish. Sold in a pack of 25, the BD-17746 is suited for technicians and installers who need a reliable, consistent bundle management solution across multiple tie-down points in a single job.

This clamp is appropriate for residential and light commercial applications where wire harnesses, conduit bundles, or tubing runs require secure fastening to a frame, panel, or structural member. It is commonly used by HVAC technicians managing low-voltage control wiring, electricians routing branch circuit conductors, and plumbers securing small-diameter tubing. The fastener-mount design allows attachment with a standard screw or bolt through the 0.25 inch hole. The steel construction and black finish make it suitable for both indoor cabinet work and protected outdoor enclosures.

Key Features

• Steel construction provides durability and resistance to deformation under clamping load
• Maximum bundle diameter of 0.25 inches fits small wire harnesses and tubing runs
• 0.25 inch mounting hole accepts standard fasteners for quick panel or frame attachment
• 0.5 inch clamp width distributes clamping force evenly along the bundle
• Black finish for low-profile appearance in finished enclosures
• Meets AMS3209 and MIL-R-3065 standards
• Pack of 25 units supports multi-point installations in a single purchase

Compatibility

Designed as a general-purpose fastener-mount cable clamp for securing small wire bundles and tubing up to 0.25 inches in diameter to panels, frames, or structural members in electrical, HVAC, and mechanical systems.

Installation Notes

Installation is typically performed by licensed electricians, HVAC technicians, or plumbers during rough-in or finish work. De-energize all circuits and shut off any associated systems before routing or securing wire bundles. Use an appropriately sized screw or bolt through the 0.25 inch mounting hole and tighten to the fastener specification listed by the equipment manufacturer. Follow applicable NEC or equipment manufacturer guidelines for bundle fill, spacing, and support intervals.