Value Collection AHSW088OY Sae Flat Washer 7/8 in Steel

Product Description

The VALUE COLLECTION AHSW088OY is a Grade 8 steel SAE flat washer designed for use with 7/8-inch fasteners. It features a zinc yellow dichromate finish that provides corrosion resistance in moderate-exposure environments. The washer meets SAE dimensional standards with a 15/16-inch inner diameter, a 1-3/4-inch outer diameter, and a thickness of 9/64 inch. Grade 8 material classification indicates high-strength steel construction suited for demanding bolted joint assemblies. Electricians, plumbers, HVAC technicians, and general tradespeople commonly use SAE flat washers to distribute load across a fastener bearing surface and prevent pull-through in structural and equipment-mounting applications.

This washer is appropriate for use in residential and light commercial trade applications where a standard SAE flat washer profile is required. Typical installation scenarios include equipment mounting, pipe hanger assemblies, electrical panel anchoring, and general mechanical fastening where a 7/8-inch bolt or screw is specified. The zinc yellow dichromate finish makes it suitable for applications requiring mild corrosion protection beyond bare steel.

Key Features

• Grade 8 high-strength steel construction for demanding bolted assemblies
• Zinc yellow dichromate finish for moderate corrosion resistance
• SAE dimensional standard: 15/16-inch ID, 1-3/4-inch OD, 9/64-inch thickness
• Designed for use with 7/8-inch screw or bolt sizes
• Inch measurement system for compatibility with standard SAE fastener tooling

Compatibility

Designed as a standard SAE flat washer for use with 7/8-inch fasteners in residential and light commercial mechanical, plumbing, HVAC, and electrical applications.

Installation Notes

Installation requires no specialized tooling beyond a standard wrench or socket set sized for the mating fastener. Always de-energize electrical systems and isolate mechanical equipment before performing fastener work in live service areas. Torque fastener assemblies according to the equipment manufacturer specifications and applicable codes such as NEC or IFGC where relevant. Do not substitute washers of a lower grade or smaller bearing surface than specified by the equipment or structural design.