Value Collection 97172 Hex Head Cap Screw 3/4-10 X 2 in 25pk

Product Description

The VALUE COLLECTION 97172 is a 3/4-10 x 2 inch hex head cap screw manufactured from Grade 5 steel with an uncoated finish. Fully threaded along the entire 2-inch length under the head, this fastener is built to Unified National Coarse (UNC) thread standards and conforms to ASME B18.2.1 dimensional specifications. Intended for general mechanical assembly and structural connections in trade and industrial applications, it is installed by millwrights, pipefitters, plumbers, HVAC technicians, and maintenance mechanics wherever a reliable, standardized hex-drive fastener is required. Sold in a package quantity of 25 pieces.

This fastener is suited for bolted connections in equipment mounting, structural framing, pipe support systems, mechanical housings, and general fabrication. The 3/4-10 UNC thread pitch is a common standard size found in a wide range of commercial and industrial equipment. The uncoated steel finish is appropriate for interior or protected environments. Grade 5 strength makes this screw appropriate for medium-duty load-bearing applications where higher tensile strength than a Grade 2 fastener is required.

Key Features

• 3/4-10 UNC thread size with 2-inch length under head
• Fully threaded for maximum thread engagement along the full shank
• Grade 5 steel construction for medium-duty tensile strength
• Conforms to ASME B18.2.1 dimensional standard
• Uncoated finish suited for dry or protected installation environments
• Packaged in quantities of 25 pieces for job-site or shop use

Compatibility

Designed as a standard 3/4-10 UNC hex head cap screw conforming to ASME B18.2.1, suitable for use in any application requiring a Grade 5 steel fastener of this thread size and length.

Installation Notes

Install using a properly sized hex wrench or socket drive rated for 3/4-inch fasteners. Verify that mating threads are clean and free of debris before installation. Apply thread lubricant or anti-seize compound as required by the application. Fastener selection and torque requirements should conform to applicable mechanical codes and equipment manufacturer specifications.