Value Collection 95596 No. 14 Self Drilling Screw 1-1/4 in

Product Description

The VALUE COLLECTION 95596 is a No. 14 self drilling screw designed for fast, reliable fastening without the need for a pre-drilled pilot hole. The hex washer head provides a wide bearing surface that resists pull-through, while the hex drive allows high torque application with standard hex drivers or nut drivers. Constructed from grade 410 stainless steel, this screw delivers solid corrosion resistance in moderate-exposure environments. The No. 3 drill point cuts through material cleanly at the point of contact. Measured at 1-1/4 inches under the head, this screw is a common choice for light-gauge metal-to-metal or metal-to-substrate connections across HVAC, electrical enclosure, and sheet metal fabrication work.

This screw is suited for light-gauge sheet metal assembly, HVAC duct fabrication, electrical panel enclosures, and general sheet metal fastening applications. The hex washer head and hex drive combination makes it compatible with standard power drivers used by HVAC technicians, electricians, and sheet metal workers. Grade 410 stainless steel provides adequate corrosion resistance for interior mechanical room and light-exterior applications where mild exposure to moisture is expected.

Key Features

• No. 14 screw size for high-strength fastening in light-gauge metal applications
• No. 3 drill point eliminates need for a pilot hole in compatible material gauges
• Hex washer head provides wide bearing surface to resist pull-through
• Hex drive accepts standard nut drivers and hex-bit power drivers
• Grade 410 stainless steel construction for corrosion resistance in moderate-exposure environments
• 1-1/4 inch length under head suits common sheet metal fastening depths

Compatibility

Designed as an OEM-style replacement or direct-use fastener for light-gauge sheet metal and metal enclosure applications requiring a No. 14 self drilling screw with hex washer head.

Installation Notes

Install using a hex driver or nut driver matched to the screw head size. Apply consistent, steady pressure when driving to allow the drill point to engage the material before the thread advances. Do not overdrive — the hex washer head is designed to seat flush without distorting the substrate. Follow applicable fastener requirements per SMACNA or NEC guidelines when used in duct or electrical enclosure assemblies.