Value Collection 95595 No.14 Self Drilling Screw 1in 410SS

Product Description

The VALUE COLLECTION 95595 is a No. 14 self-drilling screw with a hex washer head and hex drive, designed for fast, reliable fastening without the need for a pre-drilled pilot hole. Constructed from Grade 410 stainless steel, this screw delivers strong corrosion resistance suited to demanding service environments. It features a No. 3 drill point that bites into base material cleanly and a 1-inch length under head for controlled penetration depth. This screw is sold with a minimum order quantity of 50 units per order and is measured using the inch system. Trade professionals in HVAC, electrical, and sheet metal fabrication reach for self-drilling screws of this specification when speed and material integrity matter.

The 95595 is well suited for light-gauge metal-to-metal and metal-to-substrate fastening applications common in HVAC ductwork assembly, electrical enclosure mounting, roofing, and sheet metal work. The hex washer head provides a broad bearing surface that distributes clamping load and resists pull-through. The hex drive accepts a standard hex bit driver, making it compatible with impact drivers and drill-drivers used daily on residential and commercial job sites. Stainless steel construction makes this screw appropriate for installations exposed to moisture or mild corrosives.

Key Features

• No. 14 screw size with 1-inch length under head for consistent material penetration
• No. 3 self-drilling point eliminates need for a separate pilot hole
• Hex washer head distributes clamping load and reduces pull-through risk
• Hex drive accepts standard impact driver and drill-driver bits
• Grade 410 stainless steel construction provides solid corrosion resistance
• Minimum order quantity of 50 units supports job-site and shop stocking needs

Compatibility

Designed as a standard No. 14 self-drilling fastener suitable for light-gauge sheet metal and general metal fastening applications typical in HVAC, electrical, and construction trades.

Installation Notes

Installation should be performed by qualified trade professionals using an appropriate hex-bit driver set to a controlled clutch setting to avoid over-driving. Ensure the base material thickness is within the rated capacity of a No. 3 drill point before driving. Do not apply excessive torque, as over-driving can strip the hex washer head or compromise the fastened joint. Follow applicable building codes and manufacturer guidelines for fastener spacing and edge distance.