Value Collection 95593 No.12 Self Drilling Screw 1-1/2in

Product Description

The VALUE COLLECTION 95593 is a No. 12 self drilling screw with a hex washer head and hex drive, designed for fast, reliable fastening without a pre-drilled pilot hole. The No. 3 drill point bores through the substrate and drives in a single operation, reducing installation steps. Built from Grade 410 stainless steel, this screw resists corrosion in moderate-exposure environments. With a 1-1/2 inch length under head, it is well suited to light-gauge metal-to-metal or metal-to-substrate assemblies. HVAC sheet metal fabricators, plumbers, and general trade contractors reach for this size and material combination regularly on both residential and commercial job sites.

This screw is used in HVAC ductwork assembly, sheet metal enclosures, electrical panel trim, and similar light-gauge metal fastening applications. The hex washer head provides a broad bearing surface that resists pull-through on thinner materials. The hex drive accepts a standard nut driver or hex bit, making it compatible with the cordless impact drivers and drill-drivers common on trade job sites. Minimum order quantity is 50 pieces per order, sold as a single package quantity.

Key Features

• No. 3 drill point eliminates the need for a pre-drilled pilot hole in light-gauge metal
• Grade 410 stainless steel construction provides corrosion resistance for moderate-exposure installations
• Hex washer head delivers a wide bearing surface to resist pull-through
• Hex drive accepts standard nut drivers and hex-shank bits for use with common cordless tools
• 1-1/2 inch length under head suits typical sheet metal and light structural fastening tasks
• No. 12 screw size offers a balance of thread engagement and holding strength in light-gauge applications

Compatibility

Designed as a standard No. 12 self drilling screw for light-gauge metal fastening applications typical in HVAC, plumbing, and electrical trade work.

Installation Notes

Self drilling screws of this type are installed by licensed or journeyman tradespeople using a cordless drill-driver or impact driver fitted with the appropriate hex bit. Ensure the substrate material and gauge are within the rated capacity of a No. 3 drill point before driving. Apply steady, consistent pressure to prevent the point from walking on smooth metal surfaces. Do not overdrive — the hex washer head can distort or strip if torque is not controlled.